The Acoustic Energizer can effectively reduce energy loss during the transmission process, enabling sound transmission with high clarity over distance. With Acoustic Energizer, you won’t miss a thing! Low, mid, and high frequencies are all retained in perfect harmony. Now, orchestra, choir, vocalist, actor, performer, all can be benefit from this revolutionary device. Every nuance, every breath are directed to our auditory nerves. Feel the shock of the high-definition acoustic effect with Acoustic Energizer.

Features include:

• Built-in special designed protonic battery pack with 3 year warranty
• Protonic Battery can be purchased for replacement separately
• Portable: no adjustment or installation is required
• On-Off switch, convenient for comparing results
• Color: grey

In as new condition, with battery and original box. 2 units available.

Click here for more info.

Click here for full review

POWER OUTPUT:
50 watts minimum continuous from 20Hz to 20kHz. 1kHz total harmonic distortion typically 1% at 50 watts, below .05% at 1 watt. Approximate actual power available at "clipping": 52 watts (1kHz) (Note that the actual RMS power output is dependent upon both line voltage and "condition" ie: if power line has high distortion, maximum power will be affected adversely, although from a listening standpoint this is not very critical.)

POWER BANDWIDTH: (-3dB points) 15Hz to 40kHz

FREQUENCY RESPONSE: (-3dB points at 1 watt) 3Hz to 40 kHz

INPUT SENSITIVITY: 1.05V RMS for rated output

INPUT IMPEDANCE: 100K ohms unbalanced

Click here for more info.

The FM 122 MKii is a high-end phono preamplifier from FM Acoustics. It is a single-ended design, which means that it uses a single transistor per channel to amplify the signal from the phono cartridge. This type of design is often considered to be more accurate and transparent than a multi-stage design. It’s been named "Best Phono Preamplifier" by The Absolute Sound, and will give your record collection an entirely new life!

• The FM 122-MKII gives record collections an entirely new life.
• The ultimate solution in phono preamplification.
• Absolutely transparent. Performance without equal.
• Unique continuously variable de-emphasis controls allow correct replay curves of any record ever issued.
• Extremely low noise and hum levels.
• Ultra high-accuracy RIAA de-emphasis.
• The FM 122-MKII and FM 223 are the only pre-amplifier able to provide truly accurate reproduction of vinyl LP's.
• Unlimited combinations of cartridge loading allows fine tuning to any MC or MM cartridge - now and in the future.
• Large reserves in signal handling capability.
• Class A output line drivers guarantee no matching problems to different electronics.
• Zero overall feedback or feedforward.
• Entire unit built of proprietary discrete Class A circuitry.
• Special dynamic curve-tracer analyzed semiconductors used throughout entire unit.
• Freedom from usual limitations: no signal degrading IC's, transformers, hybrid circuits or op-amps.
• Proprietary technology, specialized circuitry and manufacturing methods.
• Hand-selected, precisely matched components of DIN, IEC & MIL standard guarantee utmost accuracy and long-term stability.
• The ultimate choice for record collectors, libraries, top class audio systems etc.
• No obsolescence. Modular construction guarantees easy updating.

Current model in pristine condition. With external power supply, owner's manual, and 2 extra loading modules for cartridges with different impedance loading.

The RGPC 400 Pro II retains its original Parallel Power performance, and its compact design fits conveniently behind an equipment rack.

To receive the maximum performance install the RGPC 400 Pro II as close as possible to the AV equipment. The RGPC 400 Pro II utilizes Balanced Surge Protection Design (SPD) to ensure Bidirectional Protection and Reduced Ground Interference.

Features & Benefits:
• High current on demand
• Balanced AC surge protection
• Resettable circuit breaker
• Compact design
• Compatible with UL1449 3rd edition for Type 3 locations
• Indicator lights

Comes with power cord with 20A IEC connector.

The Harmonic Resolution Systems S1 Isolation Base is a highly innovative design that eliminates noise, revealing a new level of musical performance. It is manufactured from seven different materials including a proprietary resonance control stage with billet machined aircraft aluminium trim.

The broadband noise reduction system in the S1 is optimized to the weight of your component. The weight range can also be easily modified in the future to keep your system operating at peak performance.

Still in excellent condition. Size is 19" (D) x 21" (W)

Click here for more info.

The SPU Synergy features a wood-based housing and has a revised generator system which allows for a maximum output of 0.5 mV, relaxing the requirement for high gain transformer or active preamplification systems.

While still making use of a highly polished Nude Elliptical stylus, the stylus tip mass has been reduced significantly, resulting in reduced VTF and higher tracking ability.

Technical data:
• Output voltage at 1000 Hz, 5cm/sec. - 0.5 mV
• Channel balance at 1 kHz < 1.5 dB
• Channel separation at 1 kHz > 23 dB
• Channel separation at 15 kHz > 15 dB
• Frequency response - 20-20.000 Hz ± 2 dB
• Tracking ability at 315Hz at recommended tracking force *) > 70 µm
• Compliance, dynamic, lateral - 8 µm/mN
• Stylus type - Nude elliptical
• Stylus tip radius - r/R 8/18 µm
• Tracking force range - 2.5-3.5 g (25-35 mN)
• Tracking force, recommended - 3.0 g (30 mN)
• Tracking angle - 20°
• Internal impedance, DC resistance - 2 ohm
• Recommended load impedance - 10 - 50 ohm
• Cartridge body material - Ground wood and resin composite
• Coilwire material - High Purity Copper (OFC)
• Cartridge colour - Shiny Black
• Cartridge weight - 30 g

In absolutely new condition. Never used! Only taken out for photos to be taken. Comes in original presentation case and all accessories.

Click here for more info.

Click here for full review

The AT33R features a Shibata line-contact stylus, known for its superior high-range performance and strong mid and bass sound. The stylus is mounted on a tapered boron cantilever with a double damper for reduced weight and better audio quality. The cartridge’s dual moving coils provide excellent channel separation and are affixed within a strong but lightweight VC mold to greatly reduce unwanted vibration. The cartridge uses a neodymium magnet and a permendur yoke for dramatically enhanced magnetic energy. The PCOCC (Pure Copper by Ohno Continuous Casting) coils ensure pure audio transmission.

The AT33R Reference is a limited edition cartridge specially produced to commemorate Audio Technica's 40th anniversary. Brand new in box with all accessories. NEVER USED!

The concept‘s body is carefully crafted from medium-density wood fibre (or, optionally, pressure-formed solid wood) with a selection of smart made-to-match surface finishes. The body’s upper layer incorporates a special high-tech satined plastic compound designed to minimise unwanted resonance.

The DC motor is fed by an external voltage-stabilised power supply and is completely decoupled from the chassis, isolating the record from any mechanical interference.

The concept tonearm features a magnetic bearing that is friction-free for extremely low distortion and superb performance.

In excellent condition, comes packaged with Clearaudio record clamp, turntable mat and Ortofon 2M Red cartridge for easy plug and play installation.

Click here for more info.

Click here for full review.

The Nessie Vinylmaster Record Cleaning Machine is Nessie's previous top-of-the-line.
It's designed from the ground up with ease of use, performance, and functionality in mind. Swing the fluid/brush arm over the record, hit the start button and the Nessie Vinylmaster Record Cleaning Machine automatically delivers the ideal dose of fluid and begins to scrub the detail masking grim from the grooves.

After the timer reports that the scrub is complete, simply swing the scrubbing arm out and the vacuum arm in. It automatically begins the final step of removing the fluid and gunk off the surface of the record and you're done with the side. It couldn't be any easier. The large reservoirs that hold cleaning and used fluid, make batch cleaning a breeze.

Technical specifications:
• Dimensions (L x W x H): 400 x 330 x 170 mm
• Weight without packaging: 9 kg
• Tank capacity suction 450 ml
• Speed turntable 18 rpm.
• Protection class: 1
• Protection: IP40
• Input voltage: 230 V 50Hz (100-115 V 50/60 Hz. Available)
• Power consumption "washing mode": 18 watts
• Power consumption "suction": 175 watts (500 W turbine)
• Power consumption "stand-by": <1 Watt
• Permissible ambient temperature: 5 -40 ° C

Click here for more info.

Fully refurbished Garrard 401 motor sourced from Japan, mounted on a BRAND NEW composite turntable plinth capable of mounting 2 tonearms. Comes with ISO Acoustics isolation footers.

Click here for 401 review.